M602-S

The entire working process of the wire winding system
M602-S is completely automatic and runs the program that is saved and selected (100 programs possible).
The direction of rotation of the winding material and the coil parameters are entered via a display operator prompt.
The number of turns and wire feed are also programmed. Exactly identical spirals are produced using a start-up and run-down ramp.
The wires to be wound are guided onto the mandrel via a wire guide unit. The machine stops automatically when the number of turns is reached.
The mandrel is clamped using a 3-jaw chuck and supported by a sliding counter bearing on the right-hand side. Two pneumatic supports are used when producing very long spirals on a thin mandrel. The exact wire laying is carried out by a servo linear drive unit.